FIXED TO EITHER CONCRETE OR STEEL PRIMARY FRAME
CALEDAN stud & track is offered between section width 50mm – 250mm and gauge thicknesses between 1mm and 2mm.
SECTION SIZES & TOLERANCES
- All dimensions in mm
- Tolerances (unless otherwise stated)
Profile ±1
Angular ± 1°
Straightness length /800
Twist 1° per metre length
Internal radii - typically 1.5t ± 0.5 where t = material gauge thickness - All angles 90°
- The profile dimension and angular accuracy shall be measured at a point not less than 150mm from the end of the section

CONSULTANCY
We can provide advice and support throughout the course of your project: - Inception, feasibility, design, manufacture, install and warranty.
KEY POINTS
- Feasibility
- System Type
- Procurement Route

DESIGN
We offer varying levels of design support dependant on your project needs:- indicative design(feasibility), full design option one, and full design option two
KEY POINTS
- Is Design Required?
- Level of Design Required?
- Information Required

MANUFACTURE
We manufacture all of our sections ‘in-house’ for complete quality control and confidence. We can offer bespoke section sizes to your exact requirements
KEY POINTS
- Type of Section
- Size of Section
- Gauge of Section

SUPPLY
We deliver nationally, our lead time from order can be as little as 4 days.
KEY POINTS
- Lead in Time
- Delivery Restrictions
- Vehicle Type

INSTALL
We can help put you in touch with an installer in your area if required.

THE INFILL SYSTEM
The infill system utilises stud and track to infill and extend between main structural members. The system replaces the need for masonry infill. The system will allow for structural deflection and provide a suitable backing for a range of common cladding/walling methods.
OVERVIEW & BENEFITS OF CALEDAN STUD & TRACK SYSTEMS
